Hand cutting 6mm mild steel with oxyacetylene (Panel Beating)

Pricing

16.95AUDIn Stock
DVD: $16.95 Add To Cart
Preview
  • YouTube thumbnail

Description

This presentation is the DVD component of a self paced, competency based, learning package. The demonstration consists of a brief account of the principle, assembly of the torch, setting of the flame, appropriate tip angles, cutting from an edge or within the materials boundary, the use of cutting charts and concludes with faults and likely causes.
Duration: 8 minutes.

Classifications

AQF - Australian Quality Framework
Certificate II, Certificate III, Certificate IV

Industry Classification Scheme
Automotive Industry

Copyright Description

Copyright © 2017 TAFE SA, Government of South Australia. All rights reserved. Terms and conditions apply.

Catalogue Item

TAFEshop Identifier: TAFESA-640

TAFEshop Catalogue: 92.012

TAFE SA

Related Resources


Casting a Cylinder Block

In this unit of competency the complete process of casting an automobile engine block is shown, followed by scenes of the initial machining stages to establish datum features. Attention is paid throughout that correct industry terminology is used and technical details are presented at the general interest level.
Duration: 21 minutes.

DVD$16.95

Oxyacetylene Welding - Introduction to Fusion Welding (Panel Beating)

This DVD presents the principles of gas fusion welding eg the weld line, tip clearance and forming of the molten pool or “puddle”. It demonstrates how to control the size of the “puddle" and how to move it with and without use of filler wire or rod. Concepts of fusion, down hand, forehand and penetration are explained.
Duration: 14 minutes

DVD$16.95

Plasma cutting 1 mm mild steel - Transfer Arc Machine (Panel Beating)

A brief explanation of what plasma is gives way to a short rundown on the controls and indicators existing on a typical type of machine to be found in a Panel Repair workshop. The demonstration includes setting up, current range selection, rationalisation of tip angle, comparison of cutting rates and possible problems that may occur.
Duration: 8 minutes.

DVD$16.95